Advanced Satellite Compass for Accurate Navigation: Discover the Benefits of Cutting-Edge Technology Are you tired of relying on outdated navigational tools that fail to provide the accuracy and reliability you need to navigate the open water? Look no further than our Advanced Satellite Compass – the cutting-edge solution for your navigation needs.Drawing on the latest […]
A leading manufacturer and developer of underwater transducers. Established in 2001, the company has been at the forefront of research and development in the field of underwater transducer technology. We are committed to using the latest technology to provide our customers with the best quality products possible. We have a dedicated team of engineers and […]
I believe quite a lot of service provider company has some bad experience with gyrosphere purchase either from Pakistan, Bangladesh, India reseller markets due to gyrosphere receive and tested defective. Here is one of our way to test gyrosphere , mainboard, encoder, container to ensure system works at sea after delivered to ship. Please see […]
Tested this magnetron on sperry marine S-band downmast transceiver. Found magnetron current good for short pulse, medium pulse and long pulse. Take down the magnetron current value as a gauge to predict the magnetron life span for 3-6 months usage. For ship owner who is budget constraint or vessel intend to sail to scrap yard. […]
Try to load MDD software into VDR system. Start up and found No MTI and system show slave mode. Connect AIS signal and was able to show on screen. Then swap the Manta vdr interface pcb FSD-A202 with Manta Radar interface pcb FSD-A223, system detected this pcb and change from No MTI to Tx2. Run […]
Previously use as vmft ecdis. Now it can be use as a standalone radar connected as interswitch to other radar. As the specification of the motherboard is relatively low, run the most early software and connect to BME X-band. 3-4Arcs can be shown on display transmit with PM at 12 nm.
Sperry vmft/JRC 9110/Saab R4 AIS/KH VDR/ Furuno GP150/NSR AIS/Sperry dual Mk1 gyro with switch over unit.
There are few occasions whereby PM unit ingress with water and after a prolong period, the PM unit causes system to behave abnormal due to system 12Vdc has been pull down. Please see PM unit after dismantle.
Hatteland monitor was one of the type approved marine grade monitor in the market. Why do hatteland monitor fail to work after few years of continuous operation on ship? One of the main reason was the HRX cable connect between the LCD screen and the control board, insulation breakdown causing shorting internally. Please see cable […]
Using hand to rotate the motor found not rotating smoothly. Dismantle the motor and found 6 pieces of bearing/gear inside.Top 3 pieces of bearing/gear, bottom 3 pieces of bearing/gear. Please see photos below:
